E-Cig-Reviews.com - Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

FULL LIST OF SUPPLIER DISCOUNT CODES - CLICK

20% Discount Code Added For WWW.JACVAPOUR.COM - ECR69

15% Discount Code Added For WWW.T-JUICE.COM - ECR69

10% Discount Code Added For WWW.MIRAGECIGARETTES.CO.UK - MC69

Pages: [1]   Go Down

Author Topic: Bulli mouthpiece problems  (Read 2705 times)

neilgeezer

  • Full Member
  • ***
  • Offline Offline
  • Posts: 210
  • Saluton al ĉiuj!
    • facebook
Bulli mouthpiece problems
« on: June 25, 2012, 12:39:26 PM »

Am I doing something wrong?  I have a Bulli A 2T, I keep getting E_liquid drawn up into the mouthpiece and some of it on my lips, is this normal for the Bulli?  I am using a 50/50 PG/VG mix of RY4.  I do wind up a thin piece of tissue and insert into the little hole at the tip and this draws up some of it, but it comes back again.   ???  Has anyone else had this problem?

Regards
Neil
Logged

beams9

  • Full Member
  • ***
  • Offline Offline
  • Posts: 172
  • moja lemming ni všeč višin
Re: Bulli mouthpiece problems
« Reply #1 on: June 25, 2012, 12:50:25 PM »

The tip of the mouthpiece comes out. If you push a pin into the little hole you can prise it out quite easily. Just soak up any excess liquid in there and pop the end back in again. Might be worth pulling the tank out and wiping the outside of that too.
Logged

I Shall Not Recant

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 901
  • Klaatu barada nikto
Re: Bulli mouthpiece problems
« Reply #2 on: June 25, 2012, 12:58:43 PM »

+1
Just condensation building up. A gentle bite on the end of the cartridge pops the tiny end piece off, don't swallow it lol.
Logged

Smidgeon

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 66
Re: Bulli mouthpiece problems
« Reply #3 on: June 25, 2012, 01:00:33 PM »

I get this sometimes too but just assumed I was inhaling too hard or something.  Good to know it's just condensation :)

edit - swapped to inhaling as it sounded a bit rude lol. 

« Last Edit: June 25, 2012, 01:02:21 PM by Smidgeon »
Logged

neilgeezer

  • Full Member
  • ***
  • Offline Offline
  • Posts: 210
  • Saluton al ĉiuj!
    • facebook
Re: Bulli mouthpiece problems
« Reply #4 on: June 25, 2012, 04:47:57 PM »

thanks,  ;D
I asked because it was e-liquid in the tip and I didn't like the taste.  Thanks as well for tip on removing the tip, didn't see the join till it was mentioned, bad eyesight. lol 
Logged

I Shall Not Recant

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 901
  • Klaatu barada nikto
Re: Bulli mouthpiece problems
« Reply #5 on: June 25, 2012, 04:52:12 PM »

The condensation is eliquid basically, mingin like that isn't it.
Amazing how a juice that tastes so nice when vaped tastes so faffing horrible when it gets in your mouth any other way.

I didn't know the end piece came off either, until recently. I think Scott mentioned it in a review but it might have been another vid I saw.
« Last Edit: June 25, 2012, 04:54:05 PM by I Shall Not Recant »
Logged

stevemontuno

  • Platinum Member
  • ******
  • Offline Offline
  • Posts: 4557
  • The Dude
Re: Bulli mouthpiece problems
« Reply #6 on: June 25, 2012, 06:13:22 PM »

yep i used to pop the tip out and take the other little piece under it out too and just throw them away,,,,,,vapes much better that way.
Logged

I Shall Not Recant

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 901
  • Klaatu barada nikto
Re: Bulli mouthpiece problems
« Reply #7 on: June 25, 2012, 06:37:08 PM »

Nice one Steve, I didn't know that second piece came out as well. Just removed them both, cheers!
Logged

stevemontuno

  • Platinum Member
  • ******
  • Offline Offline
  • Posts: 4557
  • The Dude
Re: Bulli mouthpiece problems
« Reply #8 on: June 25, 2012, 06:50:43 PM »

Nice one Steve, I didn't know that second piece came out as well. Just removed them both, cheers!

no worries mate ,, its quite important you take the other piece out really as it could be a choking hazard if you dont,,,i know itsmeitis told me he nearly choked on one once  :o ,,but once there both out though it definitely cures the condensation problem ;)
Logged

neilgeezer

  • Full Member
  • ***
  • Offline Offline
  • Posts: 210
  • Saluton al ĉiuj!
    • facebook
Re: Bulli mouthpiece problems
« Reply #9 on: June 25, 2012, 10:49:17 PM »

Gonna give this a try, thanks for sharing your wisdom with us Steve  8)
Logged

neilgeezer

  • Full Member
  • ***
  • Offline Offline
  • Posts: 210
  • Saluton al ĉiuj!
    • facebook
Re: Bulli mouthpiece problems
« Reply #10 on: June 25, 2012, 11:47:45 PM »

Steve,

your a genius, that is a much better vape without them bits and the condensation problem is sorted.  ;D  What a difference!  Thanks for that mate!  8)
Logged

chilly

  • Full Member
  • ***
  • Offline Offline
  • Posts: 241
Re: Bulli mouthpiece problems
« Reply #11 on: June 25, 2012, 11:58:38 PM »

Y hasnt some one mentioned this befor !! lol

just tried it and much better vape lol
Logged

Derek

  • Hero Member
  • *****
  • Offline Offline
  • Posts: 675
Re: Bulli mouthpiece problems
« Reply #12 on: June 26, 2012, 07:32:06 AM »

+1

Even makes the mouthpiece slightly more bearable too. Using this on the Biansi Imist
Logged

kingofswords

  • Newbie
  • *
  • Offline Offline
  • Posts: 12
Re: Bulli mouthpiece problems
« Reply #13 on: June 26, 2012, 11:43:40 AM »

ive taken both my mouthpieces out as i hate sucking thru a pinhole and would rather swallow small bits of juice everytime than 1 big bit every few puffs.

i wondered if this would cause any problems with airflow/wicking or even the econdensation going back in to the cart?
Logged
Pages: [1]   Go Up